Modiwell Dry Flush Toilet Product Manual

Package Contents

The package list of this product includes: a modiwell dry flush toilet main body, a charger, a user manual and a product certificate. Please check carefully when unpacking to ensure that all parts are complete.

Product Dimensions

Initial Setup

Pull the two support legs apart towards the sides until you hear a “click” sound. The bottom barrier will automatically spring open.
Use the dedicated charger to charge the product. During charging, the “Battery” indicator light will flash green. When fully charged, the light will turn off and display “100”.
Open the top cover, remove the cushion, and take off the fastening ring.
Insert the film roll onto the designated base, ensuring the arrow direction on the fastening straps faces upward.
Undo the four straps on the film roll, remove them, and secure the fastening rings.
Pull out the first layer of film from outside and lift ~20cm. Gather the top part together and push the film roll into the toilet.
Push the guide into the middle of the guide wheel vertically until no resistance. Lift the guide back to original position and replace the cushion.
Press the power switch on the back. After ~2 seconds self-check (with “beep” sound), it enters standby mode showing battery level.
Hold “Start” button >2 seconds to begin sealing (takes 2-3 minutes). Countdown displays and “beep” sounds when complete. Remove sealed bag.
Pour dedicated coagulant into storage bag to begin toilet use.
When full, repeat sealing process (step 9) and dispose properly according to waste regulations.

Attention: Charge promptly when battery reaches “25”. For new products, fully charge before initial use.

Replace garbage bags

When “STOP” appears, hold “Manual” button until all bags are dispensed.
Remove cushion and retainer rings. Install new film roll with arrow direction upward.
Undo four straps, remove them, and secure fastening rings.
Pull out first layer ~20cm, gather top part, and push film roll into toilet.
Push guide into guide wheel until no resistance, return to position, replace cushion.
Perform initial seal (as in step 9)

Tip: When not in use for extended periods, fold support legs to save space and turn off power switch to conserve battery.

Modiwell Smart Dry-Flushing Toilet Troubleshooting and Solutions

Error Code	Fault Cause	Problem-Solving Method
E1	Temperature Sensor Open Circuit Protection	Please contact us.
E2	Sealing Heating Element Open Circuit Protection	Please contact us
E3	Timeout Protection During Compression Forwarding	The device has detected foreign objects during the sealing and compression process. Please clean the sealing area from any foreign objects, turn off the power switch, and then turn it back on. If the issue persists, please contact us.
E4	Current Overload Protection During Compression Clamping	The device has detected foreign objects at the sealing position during the sealing and compression process. Please clean the area of any foreign objects, turn off the power switch, and then turn it back on. If the issue persists, please contact us.
E5	Current Overload Protection During Retraction After Compression	The device has detected foreign objects during the sealing and compression process. Please clean the sealing area from any foreign objects, turn off the power switch, and then turn it back on. If the issue persists, please contact us.

FAQs

What to do if the control panel of the Modiwell smart dry-flushing toilet has no display?

The power switch is not turned on:Press the power switch button on the back of the product again and turn on the power switch;
Battery is low/has not been used for a long time:Use the charger configured with the product to charge the product. When charging, the “Battery” indicator on the [Control Panel] flashes green. When fully charged, the “Battery” indicator stops flashing and can be used normally.
If the above problem cannot be solved for this product:Please contact us.

What to do if the product cannot be charged or is not fully charged

The modiwell dry flush toilet charger is used incorrectly. Use the charger that comes with the product to charge the product. If the charger is lost, please contact us in time.

What should I do if the power suddenly goes out while sealing the bag?

If the power level is less than 25%, the sealing may not be performed properly. Use the charger that comes with the product to charge the toilet.

What to do if you accidentally ingest coagulants？

It is strictly forbidden to consume coagulants. If you accidentally ingest coagulants, please go to the nearest hospital for treatment.

What to do if it shakes when you sit on it?

The ground is uneven: move the modiwell portable toilet to a flatter ground.
The support legs are not opened: fully open the support legs until you hear a “click” sound.

What should I do if the garbage bag in the toilet is broken?

Press the “Manual” button on the control panel to send out the broken bag. After confirming that the new bag is not broken, press “Start” for more than 2 seconds, reseal it once, and it can be used normally.

What if the bag does not disconnect/fall automatically?

There are foreign objects at the seal of the bag: clean the foreign objects remaining at the seal.
There are used bags or foreign objects at the bottom of the product: clean the used bags or foreign objects at the bottom of the product.

What should I do if there is thick smoke/strange noise?

Stop using it immediately, turn off the power switch, and contact us.

Maintenance and Care of Modiwell Dry Flush Portable Toilet

When not in use for a long time, please turn off the power switch.
If not in use for a long time, please replace the storage bag with a new one when you use it again.
The seat cushion can be removed from the product for cleaning.
If you encounter problems that cannot be handled, please contact us in time.

The above is a brief description of the product. If you want to know more about portable & dry flush toilets, you can download the product manual.

Modiwell looseal portable waterless toilet &dry flush toilet Download

Contact Us

Whether it is cooperation consultation or dry flush toilet product questions, we will provide you with all-round support with a professional and efficient attitude. Contact us now to start cooperation.

Please fill in the contact form on the right to tell us your ideas and needs, and we will contact you as soon as possible!